Current Reviews: 3

Ducati Hall Effect pick up mounting kit 2

  • Model: HE-Mounting-Kit-2
  • Shipping Weight: 1lbs
  • On order, email julie@fastbikegear for ETA
  • Manufactured by: FBG

NZ $679.50

Add to Cart:

Ducati Hall Effect pick up mounting kit 2


This Hall Effect pick up compontent kit incudes the key components you need to retro fit our Ignitecch Hall Effect pickup system to 1990's air cooled Ducatis using the the Ignitech TCIP4 programmable ignition system. 

Fits: 
Carburetor equipped Ducati 900 SuperSports (91-97)

Carburetor equipped Ducati 900 SuperSport  F.E. (1998)
Carburetor equipped Ducati Ducati 900 SuperSport CR (1998 USA)
Carburetor equipped Monster 900 CC bikes built from 91-98.

Please note the Hall Effect mountin plate attaches on top of he central cam belt cover. All of the above bikes use the same central cam belt covers with the  part numbers below. The mounting plate will not fit aftermarket or different model cam belt covers.

Lower cover part #245.1006.1A (Grey)

Lower cover part #245.1006.1AB (Black)

Includes:

  • Ignitech Hall Effect version of TCIP4 (This special version does not require an interface circuit to work with this kit)
  • 3D printed ABS Mounting plate
  • 2 x 3D printed ABS Hall Effect mounting clips
  • 2 x Hall Effect Pickups
  • Rotor with embedded magnets
  • Anodised aluminium rotor clamp
  • Full instructions for installation
  • Copy of FastBikeGear Ignitech manual

Can be used with any ignition coils and spark plug leads but for best performance we recommend using our Nology Ignitech-matched ignition coils and our UltraRace spark 8mm Silicon spark plug leads.

Why upgrade to a Hall Effect ignition trigger system?

There are two key reasons.

Reason one is to get rid of the wasted spark and give the primary current up to twice as long to build to a maximum in the primary windings of the ignition coils. To get rid of a wasted spark you usually need to move from a crank mounted pickup system to a cam mounted pick up system.

Unfortunately Inductive pickups output voltage is very dependent on the speed the ferrous lobe passes the inductive pick up.

Cams rotate at half the speed and the cam driven trigger rotors are less than half the diameter of the flywheel. Both of these factors conspire to ensure that the speed that the ferrous lobe passes the pickup up is relatively slow to crank mounted systems. Which means you sometimes get a weak and erratic ignition system if you try to operate inductive pickup on a cam driven system.

Reason two is the true timing of the ignition pulses changes with changes in speed due to the hysteresis inherent in inductive pickups. This means that the degrees of advance you set in your system does not correspond with what you actually get at all revs.

NONE of the above are issues with hall effect pickups. Hall Effect pickups can give you a very precise (accurate) and clean signal from less than 1 rpm to more than 20,000 rpm.

Most (all?) modern European cars and modern bikes hence use hall effect cam driven pickups.

Copyright © 2019 FastBikeGear. Powered by Zen Cart